Hi,

For the past week I have been ripping out everything from my "new" Anycubic Chiron and replaced the old 8-bit RAMPS to a DuetWifi... oh man what a difference! It´s completely silent (except for the fans).

I had to do a lot of re-wiring for the FANs and Z-probe, but I have everything working now!

Just wanted to say thank you to the creators of this really nice board! Thank you!

I agree, I just need to sum up everything I did, made the first print yesterday night.

ha! It worked perfectly!! Good to know until next time!

It seems to be 2.0.1

ok, thanks, I guess I have to try

I´m in the middle of a big print, and my cable to one of the fans are broken, can I hit pause, replace the cable and then hit resume ? (no power off in between)

I agree, I just need to sum up everything I did, made the first print yesterday night.

Hi,

For the past week I have been ripping out everything from my "new" Anycubic Chiron and replaced the old 8-bit RAMPS to a DuetWifi... oh man what a difference! It´s completely silent (except for the fans).

I had to do a lot of re-wiring for the FANs and Z-probe, but I have everything working now!

Just wanted to say thank you to the creators of this really nice board! Thank you!