@insertnamehere
Thank you for your reply. I would get a meanwell power supply, no point on getting the duet board and keeping the 12v supply, or maybe I could get a 12V meanwell. But I feel with 24v it would heat up the bed faster. And yes the bed heating is for 12V, I would need to upgrade that part as well. I was also checking the prices on the E3D tool changer and I was thinking maybe I should just wait and get that, because it has a lot of posibilities, and just keep the cr-10 s5 as it is, maybe get parts in time for it. Because I did have a plan to get the prusa anyway. But now with e3D being so close to being released, then I could get that and have no headaches, jut getting the tooling in time. What do you think?
Now thinking about the E3D and I also checked the prices on it, by the tiem I get a prusa, and th eupgrades to the cr10 s5, I just get a bad ass E3D tool changer, Is like geting a creality which needs a ton of upgrades or prusa and the MMU upgrade and some other upgrades to it. Well not quite, but it seems that the tool changer will be a lot of printer, and it has the duet board in it already.
I do not really understand this part:
Is the heat bed going to be 24V or mains? If 24V look at the current
requirements, you may need to move it off the Duet onto an SSR.