Hi all!

I am having some issues with my E3 and maestro and hoping you guys can help me out. I purchased the printer 2nd hand with the board installed. The guy had just installed a bltouch and was having issues.

I was able to get my offsets set but am having the following issues:

• when homing, the printer is not homing the Y axis. As long as I push it back to endstop before, it does just fine but will not home it.

• slicing a file in cura or slic3r, with even using a profile for ender3duet, the print speeds are super slow. I’m talking a 30 min print taking 4 hours. It also stops after each layer (I changed this in slic3r, but still does it)

• I cannot get the maestro to connect to my laptop over Ethernet connected to the laptop. It gives a bad ip regardless if I use 0.0.0.0 or assign one. When using M552 S1 with a static Ip, it won’t say it’s running until I unplug and replug the cable. I have not tried it connected to the router cause of the location but should work same with the Pc?

I really need to get this working and I’ve tried a couple different configurations on my files. Any ideas what to start looking for or doing?