@droftarts That's exactly what i've got. Sorted, thankyou.

Hi all,

I'm setting up a duet 2 wifi on a CR10s5, which has a 500x500mm bed. when I pre-heat the bed i get the error "Error: Heating fault on heater 0, temperature rising much more slowly than the expected 1.8°C/sec"

I can see that the temperature is going up, just not as quickly as the firmware wants but i think that's because of the size of it. How can i change this tolerance?

Board: Duet WiFi 1.02 or later
Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.0 (2020-01-03b3)
Duet WiFi Server Version: 1.23

Thanks

Hi all,

I'm setting up a duet 2 wifi on a CR10s5, everything is mostly working but the movement of the z axis is out by a factor of 10, so if i tell it to move 5mm, it moves 50mm and if i say 50mm it moves 500mm etc. Also the tool position doesn't update in the dashboard.

X and Y axis are spot on and tool postition shows correctly.

Board: Duet WiFi 1.02 or later
Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.0 (2020-01-03b3)
Duet WiFi Server Version: 1.23

Thanks