I am in the US, and i sent W3DRK a message about a week ago with no response…

Would anyone be interested in performing the repair ?

unfortunately i dont like the printer being down for who-knows-how-long. i ordered a new board, hoping to fix the old one and sell it to make up some of the difference.

Problem I have run into with the piece is to get one, i have to order 100 or 1000 of them. Crud

I never tinned them. The stock wiring from the maker's heatbed had ferrules on it, and i used those as the connection to the terminal block. I did fail at checking the screws every now and then.

Unfortunately, I am not experienced in any way on PCB soldering.

I really hope I do not have to replace this board.

Thanks in advance

Earlier this morning i was heating up the bed for another print and the bed heated, then cooled down and would not reheat. After looking at the board, (see pic below), the green connector is melted and the screw and cable will not come out. Is this fixable?

Thanks in advance,
Justin

https://ibb.co/khQQO5