Is it possible to show the status of the filament sensor switch in webinterface? I expected it to be in the Machine status section.
Best posts made by EDH
-
Filament sensor statusposted in Duet Web Control
-
RE: Duet Web Control 2.0.0-RC6posted in Duet Web Control
Extrusion control buttons 'Retract' and 'Extrude' are greyed out after RC6. Even when the hotend is hot. While /reprap.htm is working fine.
Latest posts made by EDH
-
RE: Duet Web Control 2.0.0-RC6posted in Duet Web Control
Extrusion control buttons 'Retract' and 'Extrude' are greyed out after RC6. Even when the hotend is hot. While /reprap.htm is working fine.
-
Filament sensor statusposted in Duet Web Control
Is it possible to show the status of the filament sensor switch in webinterface? I expected it to be in the Machine status section.
-
RE: Umo+ PSU for a duet3d?posted in Duet Hardware and wiring
Do you have a working config file for the UM? and do you want to share it.
-
RE: Duet Wifi Stockposted in Order discussion
I'm using the Duet Wifi on my Hypercube, it's much much better than the RAMPS i was using.
Will you share the config files for the hypercube? I build one and waiting for the duet at this moment. With my ramps it printed fine but i think the duet will show off real good prints.