Guys,

Thanks for feedback, much appreciated. Will organise a new connector, and see how I get on.

Richard.

Hi,

It was part of a Workbee kit, wiring came pre-configured, has been working fine for six months.

The connector was stiff to remove, hence latch being pushed back during the process. Looks like some of the plastic connector may have melted, externally 'brown' shadow where connectors are.

Thanks.

Hi,

While cutting today, my x-axis went haywire, and the associated motor was behaving erratically subsequently, in particular for short steps. Also noted messages 'Warning : Phase B.....maybe disconnected.

When I reviewed the wiring I noticed the associated pin's on the Duet looked like this,

Y and Z are fine, X is the only one in this state.

I am hoping this is a motor failure, any insights ?

Thanks for your help,
Richard.