Problem was a bad crimp on the out/in pin at the board. I started re-crimping each wire and it worked after re-crimping it.

I do appreciate everyone's help/input. Now on to wiring the rest of the board

I do appreciate everyone's help/input. Now on to wiring the rest of the board

Problem was a bad crimp on the out/in pin at the board. I started re-crimping each wire and it worked after re-crimping it.

I tried inverting and still shows always triggered. I took nick's ;endstops and ;z-probe and pasted them into mine but it did not fix the problem. new config.g attached

config.g

Generating a new config file with https://configtool.reprapfirmware.org/ does not change the triggering problem. I am on the latest stable release 3.2.2 firmware

config.g

Currently building a new printer, first time using Duet2 WIFI and an IR sensor. The IR Sensor is always triggered. The LED on the sensor is off unless I put something near it. I believe it's a config issue but I'm unable to figure it out. Already updated to the newest 3.2.2 firmware and tried various m558 configs. I've attached my config.g and photos of the pin outs. Any help would be appriciated.

config.g