Hi all I recently came into a Anycubic Predator. I printed a benchy and a few other small prints and put it away for a bit. I just pulled it out of the closet and set it up. For some reason it seems like my X endstop is not working. The light on the actual endstop goes out indicating its working but the duet is not cutting power to the motor. When the other 2 home the light next to the plug in for the motor goes off completely on the duet. On the X it just dims rather than going out completely. FYI I did not install the duet and this is my first printer with a duet. If there is any information I can provide to help or if you want videos of it happening let me know.