I have a problem with cooling the print. When I start the print file, the cooling starts immediately, and the slicer is set to only layer 3. and does not turn off after printing is complete.

Slicer Simply3D
Duet 2 WiFi sys board 3.2.2

@jay_s_uk so not to worry about it?

Hello
I set this code for the T-D500 thermistor:

M308 S1 P"e0temp" Y"thermistor" T4606017 B5848 C5.548428e-8 R4700 H0 L0
M950 H1 C"e0heat" T1
M307 H1 B0 S1.00
M143 H1 S350

and incorrectly shows room temperature, instead of 24C it shows 11-13C. At 95C the board shows 91C.

How to calculate the correct parameters for this thermistor from this table?