Ok so the new config.g obtained by the last step is working on Cartesian coordinates now. However my z end stop is not responding, my extruder just crashes into build plate. I've tried active high and active low setting but same response. My x and y are on active high and are the same type of opto sensors. The opto sensor has an led on it that is lit when not tripped, I see this led go off when the flag passes between the sensor but I don't think the board is processing the signal right.
Thanks

Ok so I am updating the board on a 3dstuffmaker Mega Prusa to the Duet. For some reason when I go to move the x axis both the x and y axis moves. I'm not sure if this is a wiring issue or a software problem. Thanks for helping.

Can someone help me with port forwarding my duet wifi so I can access it away from home. I would like to shut it down if I see a failed print on my web cam. I believe I have already set up the forwarding to port 80 on my router using the ip address given to the duet in the router settings. Yougetsignal.com also confirms the port is open. How do I access the web control after I have forwarded the port? Do I type my router IP address into the web browser search bar?
Thanks in advance for the help.