@EasyTarget This is really useful tool! Thank you!

@EasyTarget This is really useful tool! Thank you!

@gloomyandy Thanks for the reply. I will try containing the G1 H4 in a macro with my settings for stall detection. I was not aware of the H parameter in RRF 3+.

Hi all,

I am trying to figure out how I can use either sensorless homing or stall detection to measure the length of a single axis.

Ideally, I trigger a macro that sends one axis away from the home position until it hits the end of its travel - then stores that location in a variable.

I understand there will be limited accuracy due to the loss of steps, but that is ok for my application.

Any help or direction would be greatly appreciated!