@t3p3tony if i set x to max. instead of min
at 0 it will show 350
there is a way to overcome this?

hi
i read in here:
https://duet3d.dozuki.com/Wiki/ConfiguringRepRapFirmwareCoreXYPrinter#Section_Testing_motor_movement
this:
Important: make sure that you have chosen a right-hand axis system. That is, looking down on the printer the +Y direction should be 90 degrees anticlockwise from the +X direction. If instead it is 90 degrees clockwise, you have a left-hand axis system, which will give you mirror-image prints.

i have blv cube my y end stop is left and also my x endstop

how can i make that the prints will not be Mirrored
and not change my end stop place

tray switch motors with m584 and change motors direcion
and its start moving to worng side ....