Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. ciaossu
    • Profile
    • Following 0
    • Followers 0
    • Topics 0
    • Posts 2
    • Best 1
    • Controversial 0
    • Groups 0

    ciaossu

    @ciaossu

    1
    Reputation
    1
    Profile views
    2
    Posts
    0
    Followers
    0
    Following
    Joined Last Online

    ciaossu Unfollow Follow

    Best posts made by ciaossu

    • RE: Cancel/Skip Individual Objects During Print

      I am on board for the ability to cancel object on the Duet 2 for sure. I use the cancel object or exclude region in octoprint when a small piece breaks free on a plate full of items. This has saved many prints from being complete failures.

      posted in Firmware wishlist
      ciaossuundefined
      ciaossu

    Latest posts made by ciaossu

    • RE: Problem with Magnetic Sensor

      I just purchased a filament sensor from Filastruder and set it up. My mount is not ideal according to the directions because I do not want to mount the sensor on top of the bondtech extruder that is set up as a direct drive on a Railcore. This would add a lot of moving weight. So the sensor is mounted outside the printer and there is a long ptfe tube between the sensor output and the bondtech. I was able to run 3-4 12 hour prints without issue. Now though the sensor stops and says not enough movement was detected.

      Is there a way to configure the sensor to simply detect any movement over x amount of time and not try to exactly sync the movements to the print? Should I be using the switch and the magnet sensor? I tried opening up the tolerance to work over a wide range but that did not help.

      Settings:
      Duet3D magnetic filament monitor on input 3, enabled, sensitivity 24.70mm/rev, allow 20% to 250%, check every 3.0mm, version 2, measured sensitivity 24.82mm/rev, min 91% max 105% over 160.8mm

      If you need additional information please let me know.

      posted in Filament Monitor
      ciaossuundefined
      ciaossu
    • RE: Cancel/Skip Individual Objects During Print

      I am on board for the ability to cancel object on the Duet 2 for sure. I use the cancel object or exclude region in octoprint when a small piece breaks free on a plate full of items. This has saved many prints from being complete failures.

      posted in Firmware wishlist
      ciaossuundefined
      ciaossu