Also stupid question, does this need connected to my router or to my laptop ethernet port? I am connected to the ethernet on my laptop directly to the Duet 3 with ethernet.

@bearer Yes that worked and I was able to load the firmware! I had to replace it in 3 difference locations inside the driver files. Now I can get into YAT and it said my IP address was 0.0.0.0 using the m552 command.

Now I connected with the ethernet cable and in chrome, when I type in 0.0.0.0 it still doesn't load. any thoughts?

I restarted my laptop and under device manager > Other Devices I can find the Duet now. I am using the link below to download duet usb drivers and I am wondering if there is another link for duet 3 specific drivers. When I try to use this driver is says it could not find the driver files inside the folder.

@bearer Ahhh Gotcha, Yes the jumper is removed.

@bearer I definitely used a jumper on the erase pins to startup the board so it makes sense the firmware is gone, but the problem is once I flash it with new firmware, it doesn't show up at a Duet 3D Printer device in Device Manager. It still shows as Bossa Program Device

Okay so I am trying to connect with YAT and I am still seeing the board only come up in the device manager as Bossa Program port. I followed the thread link below to do the fall back procedure since it sounds like the firmware wasn't on the board.
https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware#Section_Fallback_procedure_Num_3

I downloaded and used the "Duet3Firmware_MB6HC.bin" and loaded this with Bossa and check marked "Erase all, lock, and boot to flash". After the write/verify is successful, I reboot the board and it still shows as Bossa Program Port.
https://github.com/dc42/RepRapFirmware/releases/tag/3.0

Has anyone successfully loaded a firmware on Duet 3?

@bearer said in Duet 3 Web Address in Stand Alone Mode:

hth

Thanks I will give this a try today. Have you connected using YAT or are you using a different terminal?

Hey everyone, I am primarily a Duet 2 Wifi user and I recently got a duet 3 for my Cartesian printer. I am using it in stand alone mode and connecting with an ethernet cable, but I cannot get connect to the web interface.

I currently did the reprap configurator and followed the link below for downloading the right files to run to the SD card, but I cannot find anywhere what the IP address is or what I should type into the web address bar to connect into the web address bar.
https://forum.duet3d.com/topic/13999/duet-3-files-needed-for-standalone