@chrishamm
Nice Work Thanks alot!
Iam happy now ! I can use the RPI with ffmpeg & Telegramm

@chrishamm said in Problem Uploading Gcode files to Duet Web Control:

M104 S0 S1; Hotends aus

Thank you so much! damn Endscript. I add only 1 Hotend Extruder atm. The Script is from my old board there was 2 Hotends... Sorry for my dumpness.

But why runs the Gcode on the Duet3 in Solo mode and with DuetPi i gives the Failure ?

Thanks Alot for you incredible Help!

a.gcode

Here it is. I hope u see somthing. Created with S3D

Kind Regards

Dominik

@chrishamm
I will share you the File tomorrow evening. I'm at the moment on a Buisness Trip.

It is very confusing that i can Upload the File to the Standalone Duet 3 but not on the DuetPi Version.

Installed in this Case the Pi now 3 Times new to rule out Installation Problems.
We will see when u get the GCode file.

Thank you very much for the help.

Hi Chrishamm,

thanks a lot for reply. I'm a little bit Confused because when I take the Duet 3 Solo without Pi, the same Gcode file can be Upload without Problems. I created the File with s3d and Cura. Same problems.

Kind regards

Dominik

Hello,

Changed my system now to DuetPi. All ist Working but i cannot upload Gcode Files to the Web Interface.

Get this error:

Failed to get file info for SmartTemperatureTower_PETG_220-265.gcode
Operation failed (Reason: Command GetFileInfo has reported an error:
[CodeParserException] Duplicate S parameter)

Information:
Board: Duet 3 MB6HC (MB6HC)
DSF Version: 1.2.3.0
Firmware: RepRapFirmware for Duet 3 MB6HC v0.6 or 1.0 3.0 (2020-01-03b3)

Can someone help me ?

Greetings
Dominik