Posts made by Nicky T

This is what I get from route print. the pictures are reversed.

We have a router and modem. I am not sure what you mean by network set up. There is no password for the network if that is what you mean. All I have been doing is following the setup guide from the link on the card that came with the device. Before that, we tried using other software to connect it as well and it did not work. I installed the driver on the computer from reprap and it is all on windows 10. Would a screen image of YAT help?

This is what I get when I put in M552: "Network is enabled, configured IP address: 192.168.1.14, actual IP address: 192.168.1.14"

I try to ping this IP address and the command prompt window says that the "request timed out"

Hey everybody,

So I recently just purchased the Duet3D with Ooznest CNC and have had immense trouble configuring the Duet Web Control. I have followed the guide to connect via ethernet but have not had any luck actually connecting. I keep getting stuck at the section that says to send the command: M552 S1 and wait 30 seconds for a configured IP address for the Duet. Every time I run it I do not get a response and it just says "ok." I don't know what I am doing wrong. I have it connected directly to the Router and have my laptop connected wireless. My driver should be up to date and everytime I have tried to ping to the preconfigured IP address for this Duet is always says "request timeout." If anybody could help me that would be so amazing! I don't understand why it is so hard to actually get this thing to run!! If you need pictures of YAT or whatever it may be, just let me know!

Thanks and all the best.