Posts made by Ptitmickey

Wiring is correct.
Yes you're right, comment is not up to date (from the sample config).
But I'm using thermistor from E3D.

Hi guys,

I try to get working with my Jubilee 3D printer and config file.
My setup is a duet 3 mainboard 6HC with an expansion board 3HC.

My hotend is an E3D V6 ultimate :
https://www.filastruder.com/products/e3d-v6-ultimate-edition?variant=32360498298951

This is my config.g section :

; Tools
; Heaters and sensors must be wired to main board for PID tuning (3.2.0-beta4)
M308 S1 P"1.temp0" Y"thermistor" T100000 B4725 C7.06e-8 1 A"Outil 1" ; PT100 on main board
M950 H1 C"1.out0" T1                      ; Heater for extruder out tool 0
; M307 H1 A1252.3 C361.3 D5.3 V24.0 B0    ; from pid tuning without sock
M307 H1 A811.4 C309.4 D4.7 V24.0 B0       ; With sock
M143 H1 S300                              ; Maximum temp for hotend to 300C

When I try to calibrate "Outil 1" extruder heater, I get this error message :

M303 H1 S250
Error: M303: heater 1 reported error 'sensor open circuit' at start of auto tuning

Do you know what I'm doing wrong ?

Thanks for your help, best regards.

Nicolas