• Tags
  • Documentation
  • Order
  • Register
  • Login
Duet3D Logo Duet3D
  • Tags
  • Documentation
  • Order
  • Register
  • Login
  1. Home
  2. tomwor2
  3. Posts
  • Profile
  • Following 0
  • Followers 0
  • Topics 0
  • Posts 2
  • Best 0
  • Controversial 0
  • Groups 0

Posts made by tomwor2

  • RE: New M-code to send a network request

    @DIY-O-Sphere said in New M-code to send a network request:

    that it's not required.
    You can use the PS_ON pin to switch the printer of.
    Or a more current solution....

    Thanks for the input. I was hoping to avoid having to turn on a node-red flow when I am printing and not have to buy more hardware but your input made me think around it a couple of more turns and I think I have come up with a workable solution.

    I do not have a separate PSU for 5v as I plan to run the board only when the printer is turned on but I do have a smart home controller.

    I'll simply activate the node-red flow every time the smart plug for the printer is turned on and turn it off after having ensured the printer is turned off. The smart plug was anyhow needed to shut the printer down when ready and I can also measure the power I consume for printing 😀

    posted in Firmware wishlist
    undefined
    tomwor2
    31 Jan 2021, 08:48
  • RE: New M-code to send a network request

    Is there any new information on this topic? I am just getting my new printer fired up and was hoping to be able to send a message to node-red running on a Pi. Node-red manages most protocolls mentioned in this thread including MQTT, HTTP UDP and TCP, so for me it does not really matter which protocol that is used. It would be great to be able to for example shut down the machine when it's done using a smart plug och get a message when it runs out of filament etc.

    posted in Firmware wishlist
    undefined
    tomwor2
    25 Jan 2021, 21:40
Unless otherwise noted, all forum content is licensed under CC-BY-SA