What was the outcome of this? I have the FilaPrint as well and are going through my options of going dc42 IR probe in the future. I'm essentially trying to figure out if there's anything I should do before putting the FilaPrint on my precision plate (i.e. paint it).
Latest posts made by pakerfeldt
-
RE: Problems calibrating with IR sensorposted in Tuning and tweaking
-
RE: Safe to use internal stepper driver for 2.0A?posted in Duet Hardware and wiring
Thanks
And what is the consequence of stretching the limits? I suppose the drivers or even worse the entire board would burn up?
-
Safe to use internal stepper driver for 2.0A?posted in Duet Hardware and wiring
Hi,
I'm building a CoreXY printer and plan to use my old Duet 0.6 board (which I'm very pleased with). The motors (for XY and E) I've ordered are rated 2.0A (http://www.ebay.com/itm/331440962687). Is it safe to use these with the internal drivers on the Duet? I have read the Wiki but I'm still not sure what might happen if it's too much, since 2.0 seems to be the very upper limit for this board. Will I break anything or just realize I need external stepper drivers? If the latter, than I can just as well skip ordering external drivers for now and try using the Duet directly? Would prefer that ofc but I don't want to break things.
Thanks,