That worked thank you so much for all your help. I was using the v3 config because my endstops didn't work with the v2 config but everything works now thanks again!!!!
Latest posts made by Zac Coli
-
RE: how to disable a drive and it's monitoring?
-
RE: how to disable a drive and it's monitoring?
@Phaedrux First off thanks for helping out so fast I was able to upgrade firmware up to 2.05.1 and my original error went away. However as errors do a new on popped up, "Error: Temperature reading fault on heater 1: unknown temperature sensor channel".
I think this means my M308 command has the wrong channel in it but I couldn't find the right channel here's the command from the config.g " M308 S1 P"spi.cs1" Y"rtd-max31856" " this is from the RRF configurator as I'm using a MAX31856-based daughter board.
-
how to disable a drive and it's monitoring?
I had the y-axis stepper driver fail on one of my duet boards. I'm going to replace it but I have some prints I need to get done in the meantime. I've removed the burnt out driver completely from the board and remapped the y-axis to the E1 drive. This seems to work but I still have a short to ground and overtemp fault on drive one (the y-axis). I looked at the G-code reference and found M569 with the R param set to -1 I put this in my config.g along with an M584 to remap the drives but I still get those errors reported on drive one. What am I doing wrong? How can I ignore drive one completely? Thanks for taking the time to read this and help out a random stranger .
Board and firmware info - RepRapFirmware for Duet WiFi version 1.19 running on Duet WiFi 1.0