hotend pwm value
-
please help me ? I have blv mgn hypercube 3d printer. my hotend M303 H1 S190 when I write, the value goes above 190 and doesn't stop
-
https://duet3d.dozuki.com/Wiki/Gcode#Section_M303_Run_heater_tuning
Right there it says that it can/will overshoot the target temp when calibrating....by how much depends on how powerful the heater cartridge is. Something to watch out for that I have seen all too often is to make sure you have the correct voltage heater for your hotend. Many people will order a hotend or heater cartridge that is rated for 12 volts yet have a 24 volt power supply...this will make it heat up crazy fast and be pretty much uncontrollable and unsafe.
-
no, I have 24v hotend end 24v powersupply
