• Tags
  • Documentation
  • Order
  • Register
  • Login
Duet3D Logo Duet3D
  • Tags
  • Documentation
  • Order
  • Register
  • Login

WiFi connection failure after a reset

Scheduled Pinned Locked Moved
General Discussion
3
5
1.1k
Loading More Posts
  • Oldest to Newest
  • Newest to Oldest
  • Most Votes
Reply
  • Reply as topic
Log in to reply
This topic has been deleted. Only users with topic management privileges can see it.
  • undefined
    mhackney
    last edited by 26 Dec 2016, 15:45

    I commissioned a new delta with a Duet WiFi late last week and it has been working well. This morning I was doing some probe tuning running the grid compensation and had the probe crash into the bed. I clicked the Emergency Stop button on the web interface. Now, the Duet WiFi is not connecting to my wifi network at all. I've rebooted the machine several times, waited 30 minutes between the reboot attempts and still it won't show up on my network router and I can not connect to it. Any suggestions on what to do and more importantly why I can't connect?

    My 3D Printing blog: http://www.sublimelayers.com
    Coming this summer: "3D Printing Strategies - the art of perfecting your designs and prints"

    1 Reply Last reply Reply Quote 0
    • undefined
      dc42 administrators
      last edited by 26 Dec 2016, 17:18

      When you enable wifi by sending M558 M552 S1 from PanelDue or over USB, do you get a message after 30 seconds or so saying that the wifi module has gone into access point mode?

      Duet WiFi hardware designer and firmware engineer
      Please do not ask me for Duet support via PM or email, use the forum
      http://www.escher3d.com, https://miscsolutions.wordpress.com

      1 Reply Last reply Reply Quote 0
      • undefined
        mhackney
        last edited by 26 Dec 2016, 20:46

        David, it rectified itself. Came back after lunch and tried to connect and this time it did. No problems sense.

        I'll try the M558 S1 if this ever happens again.

        My 3D Printing blog: http://www.sublimelayers.com
        Coming this summer: "3D Printing Strategies - the art of perfecting your designs and prints"

        1 Reply Last reply Reply Quote 0
        • undefined
          dintid
          last edited by 27 Dec 2016, 10:13

          @mhackney:

          David, it rectified itself. Came back after lunch and tried to connect and this time it did. No problems sense.

          I'll try the M558 S1 if this ever happens again.

          Code is M552 S1 and not M558 🙂

          I've had problem connected using IE, but works fine in Chrome.

          RepRapFirmware supported G-codes: https://duet3d.com/wiki/G-code

          1 Reply Last reply Reply Quote 0
          • undefined
            mhackney
            last edited by 27 Dec 2016, 16:16

            Got it on the M552.

            @dintid, I have quite a few Duet WiFi equipped printers here and use Chrome. I've not had connection issues at all in over a year (I worked with Chris H to capture network traffic to help him improve the network code about this time last year). This particular issue was odd and maybe just a fluke. Not had a problem since.

            My 3D Printing blog: http://www.sublimelayers.com
            Coming this summer: "3D Printing Strategies - the art of perfecting your designs and prints"

            1 Reply Last reply Reply Quote 0
            3 out of 5
            • First post
              3/5
              Last post
            Unless otherwise noted, all forum content is licensed under CC-BY-SA