New RepRap config tool crashing my delta into carriage 3 endstop
-
after tweaking my config in the reprap configtool released yesterday upon homing the printer the printer just crashes into carriage three endstop (NC) over and over, has anyone else had any issues?
-
The tool is a very general starting point, not a perfect config.
Also, it is best practice to check endstops with your finger and ensure they show up as not-triggered and triggered (as appropriate) by issuing M119 commands. Home the machine only after that looks right.
.How are your endstops wired? Normally Open? Normally Closed?
How are they configured? Something like this in config.g?
M574 X2 Y2 Z2 S1 ; 2= Endstops at "top" of axis, S1= active high
With the carriages away from the stops, M119 should return this, until you press a switch with your finger:
M119 Endstops - X: not stopped, Y: not stopped, Z: not stopped, Z probe: not stopped
Pressing a switch on a Delta results in:
M119 Endstops - X: at max stop, Y: not stopped, Z: not stopped, Z probe: not stopped
-
@usscody said in New RepRap config tool crashing my delta into carriage 3 endstop:
after tweaking my config in the reprap configtool released yesterday upon homing the printer the printer just crashes into carriage three endstop (NC) over and over, has anyone else had any issues?
Is this a delta? If so, see https://duet3d.dozuki.com/Wiki/ConfiguringRepRapFirmwareDeltaPrinter?revisionid=HEAD#Section_Testing_the_motors_and_endstops_individually.
-
New here, but noticed they removed the wifi config option from the configuration page. So you cant add the Sid and Password before exporting and copying to the SD card
-
@shaun said in New RepRap config tool crashing my delta into carriage 3 endstop:
noticed they removed the wifi config option from the configuration page. So you cant add the Sid and Password before exporting and copying to the SD card
it was because it ended up being left in the config.g by users causing issues. its best to use the process describer here:
https://duet3d.dozuki.com/Guide/1.)+Getting+Connected+to+your+Duet/7#s10
to get on the wifi