Please help.

[weput]

Hi
a friend of mine gave me (as in gift) a duet wifi… so im configuring the thing etc... homed X axis ok then the system halted.... the board is not responsive either with USB or wifi.

the diag red led is on... honestly i dont know what to do. Please advice.

[Jackal]

See if this helps
https://duet3d.com/wiki/What_to_do_if_your_Duet_or_Duet_WiFi_won%27t_respond

[weput]

i get 4 lights (3 reds, one green) but no COM on the PC…

[weput]

ok…
i managed to get it connected to COM4.. but cant actuyally connect... so I load the firmware with SAM-BA.

thank you jackal for your response...

[Cata]

Do you check the endstop wires? Duet wifi uses a different order in the pins. If you connect wrong the board die

[weput]

@Cata:

Do you check the endstop wires? Duet wifi uses a different order in the pins. If you connect wrong the board die

i assume thats what happened.

I have to rewire the connectors and stuff as i put my old mks gen in… but i assume board is fully functional. Such design must have several short protections...

[Cata]

Can't have protection in signal line. Try with your mks

[dc42]

The Duet WiFi is better protected from user wiring errors than most other controller boards. What is the current problem?

[weput]

@dc42:

The Duet WiFi is better protected from user wiring errors than most other controller boards. What is the current problem?

current problem is that i have to redo the connectors…. i put my old mks board in as i only have one printer.

dumb ass question... will you support the smartcontroller 2004 LCD ?? i hear the 12864 will be supported soon....

[dc42]

Support for other LCDs is low on the priority list because there are so many other features that users have requested - see https://www.duet3d.com/forum/thread.php?id=961. They will have to be 3.3V-compatible LCDs, not 5V ones unless you use level-shifters.

Have you considered using your smartphone or tablet to control the Duet WiFi via the web interface, instead of an LCD?

[weput]

@dc42:

Support for other LCDs is low on the priority list because there are so many other features that users have requested - see https://www.duet3d.com/forum/thread.php?id=961. They will have to be 3.3V-compatible LCDs, not 5V ones unless you use level-shifters.

Have you considered using your smartphone or tablet to control the Duet WiFi via the web interface, instead of an LCD?

in fact i am… my current running setup is mks gen with octopi and i control everything remotelly... but i trend to use the kill switch of the smart controller board.