@3dpmicro said in Help me ID this heatbreak?:

E3d V6 is the same thread size on both sides. M6x1 or 1.25. I don't recall
Yours appears to have 2 different thread diameters

Have you ever seen a e3d v6?

Never trust in m3d

Old discussion, without firmware support it is useless to think about how or which display can be connected.
There are some options but they are made by users and not all well documented.

arduino+12864 connected in paneldue port

@gtj0 Thanks, i re-read again the wiki and its fine for my use.

Will there be a variant that does not use a raspberry?

@dc42 said in Duet 3 first-generation prototype giveaway:

this board was designed to be capable of running standalone, without an attached Raspberry Pi

@3dpmicro said in Help me ID this heatbreak?:

E3d V6 is the same thread size on both sides. M6x1 or 1.25. I don't recall
Yours appears to have 2 different thread diameters

Have you ever seen a e3d v6?

@fma https://www.youtube.com/watch?v=-9oGpRvEbT4

@fma said in PETG Drying:

Some companies are now making real-time filament drying:

• Fyladry (interview here: https://youtu.be/-FvGRm7I1Dc?t=307)
• Thordsen 3D (interview here: https://youtu.be/0cj6dqMgja4?t=1032)

Filadry its a scam, Fake specs and low quality product. Its like an anet dryer.

70C 6 hr here

@t3p3tony
Can this be a problem? From the link
""This method works by creating a DHCP server on the Pi's ethernet connection and internally it 'shares' the internet access between eth0 and wlan0. A device connected to the Pi's ethernet will get an IP address from the Pi, not the WiFi, but will still have internet access. ""

Its a simple ir endstop. Only need to setup the deploy going to the X min and the retract going to z0.

What bondtech extruder?