Firmware 2.04RC1 available

blt3dp

I'm running 1.22.6

garyd9

At this point, can this version of the firmware considered stable?

T3P3Tony

dc42

2.04RC1 is stable, however there are a couple of 2.03 bug reports that I want to investigate before I do the 2.04 release. Unfortunately there is a tight deadline to meet for the Duet 3 firmware development, so it may be a while before I get back to 2.04.

garyd9

@dc42 said in Firmware 2.04RC1 available:

2.04RC1 is stable, however there are a couple of 2.03 bug reports that I want to investigate before I do the 2.04 release. Unfortunately there is a tight deadline to meet for the Duet 3 firmware development, so it may be a while before I get back to 2.04.

Oh, I completely understand about deadlines and RRF/Duet3. (In fact, I'd be on the duet3 first-run list if I wasn't extremely tight on money these days.)

I really just needed to confirm that this RC is (at the moment) the best stable choice for a delta printer.

Thank you
Gary

boldnuts

@garyd9 I have been using this 2.04RC1 version on my delta since it came out with no issue's at all, go for it!.

jay_s_uk

Same here. I use it on both my deltas

garyd9

Thanks - it seems to be working fine for me (so far*.)

* Typically, if I say something is working, it breaks immediately afterwards. Hopefully, by qualifying the statement with "so far", things will stay working.

blt3dp

I had definite problems with it, I’m totally willing to re-upgrade. If DWC stops being able to connect to the firmware again, can I still run M122 in a terminal connected via usb?

Those with Deltas that haven’t any problems with it, what DWC are you running?

jay_s_uk

DWC 2.0.0-RC7

boldnuts

@jay_s_uk said in Firmware 2.04RC1 available:

DWC 2.0.0-RC7

DWC 2.0.0-RC7

blt3dp

@jay_s_uk said in Firmware 2.04RC1 available:

DWC 2.0.0-RC7

@boldnuts said in Firmware 2.04RC1 available:

DWC 2.0.0-RC7

I just re-updated to 2.04RC1 and this time I updated to DWC 2.0.0-RC7, seems like I'm not having the issue with the higher than normal first layer this time. Wierd, autocalibration calibrated to the deviation I expected, but it seems to be normal now.

Seems fine like last time but we'll see after I power it off and back on in a couple of days.