Around the fans ...
-
Hi,
Help with fans...
i have:
Hardware:
- 2x30mm fans (linked) conected to FAN2, for heatskin
- 1x40 mm fan connected to FAN1, layer fan
- 1x40 mm fan connected to FAN0, layer fan
Software (config.g)
; Fans M106 P0 S1 I0 F500 H-1 M106 P1 S1 I0 F500 H-1 M106 P2 S1 I0 F500 H1 T60 ; Tools M563 P0 D0 H1 ; Define tool 0 G10 P0 S0 R0 ; Set tool 0 operating and standby temperatures
The issue:
- If i heat nozzle, when reach temperature, two fans linked, powe on
- But, when i command in DWC, manual, that Nozzle fan go 100%, slicer control of FAN 1, its linked.... the same manner if i command by DWC, that fan1, go 0%, Nozzle fan too goes 0%, are linked too
- When command for DWC, nozzle fan, in console can read: M106 S0.xx, but when command for DWC, fan1, in console can red: M106 P0 S0.xx, and Fan1, in console can read: M106 P1 S0.xx.
Maybe the solution its change Heatskin fan to Socket of FAN0???
Why?
-
YES...
With these i have solved....
I HAVED CHANGE HEATSKIN FAN TO FAN0 SOCKET