Prusa MK3 - Stall detection help
-
I am just now swapping my Prusa MK3 over to a bear frame and using the Duet Wifi 2 board. I cannot for the life of me get this thing to home correctly. I am using the default Prusa LDO motors. Can someone share the settings for config.g and the home ones so I can see what I am doing wrong? Thanks!
-
I haven't used those particular motors, but the guide to using stall detection is at https://duet3d.dozuki.com/Wiki/Stall_detection_and_sensorless_homing. I find a stall sensitivity of about 3 in the M915 command is good for most motors.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com -
@dc42 I think my home commands are not correct. Can you share an example of what it should look like?
-
@dismania said in Prusa MK3 - Stall detection help:
@dc42 I think my home commands are not correct. Can you share an example of what it should look like?
See the link provided above.
-
Chris Warkocki made the settings for Duet and MK3.
See here: https://www.patreon.com/posts/duet-prusa-files-30115916
But try not to just copy the settings, see what he did and try to implement it in your settings.
