Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    To use a non pwm fan for gcode control

    Scheduled Pinned Locked Moved
    General Discussion
    1
    1
    435
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Fickertundefined
      Fickert
      last edited by

      So i am very confused oh how to hook up a 5v fan without pwm for gcode use to be controlled via the sliced print code.

      I had the fan hooked into the fan0 and system settings for fan0 as follows.

      M106 P0 S1 I0 F100 H1 T45 ; Set fan 0 value, PWM signal inversion and frequency. Thermostatic control is turned on

      I can't get it to kick on with the m106 sxx command with range of 0-1 and ranges of 1-255 or by putting my hot end above 45C.

      1 Reply Last reply Reply Quote 0
      • First post
        Last post
      Unless otherwise noted, all forum content is licensed under CC-BY-SA