Z=0 DATSUM WAS NOT DETERMINED PROBING
-
I know from reading the previous post on this that this is when a printer has a z end stop and a probe on the z. Well my expensive Delta was doing just fine until I updated. No I cannot get it to pass a mesh bed leveling to save my life. I have G30, then G28 then probed and every variant. I am just so frustrated and lost.
Why would Duet change this? When it worked?
-
Running G30 and then G28 would discard the information from G30.
-
What firmware version are you using? There was a bug in 2.03 that was causing some miscalibrations with delta printers. Use 2.04 latest RC instead.
-
really? Man I have been fighting this thing for a week and theirs glitch? Yeah it's like it won't use the mesh leveling. Thank you