Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Hotend Heater Cartridge always powered during print?

    Scheduled Pinned Locked Moved
    My Duet controlled machine
    2
    3
    145
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • alexprintundefined
      alexprint
      last edited by

      Hi to all,

      just a simple question: Is the heater always powered during prints?

      I´m just asking because I´ve noticed with my external Mosfets that the hotend is always on, just not on 100% but at about 40% to 50% (guessed by brightness of control light)
      Is this normal behaviour of Duet 3 ethernet @ Firmware 2.05 or do I have any issue in my setup which will cause my heater cartridge to die way too early?

      My rig: TRONXY X5SA coreXY upgraded to Duet 2 ethernet and MicroSwiss all metal hotend, dual PSU 24V

      Thanks for any advice!

      1 Reply Last reply Reply Quote 0
      • JamesMundefined
        JamesM
        last edited by

        Yes, it's common since it uses PWM (pulse width modulation) to switch it on and off rapidly to maintain temperature.

        alexprintundefined 1 Reply Last reply Reply Quote 1
        • alexprintundefined
          alexprint @JamesM
          last edited by

          @JamesM Well, then I´m quite happy again.
          Thanks for your fast answer, happy new year!

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA