BLTouch Problem with Home Z

CupaCabra

Hello, I have a little prob. with my BLTouch I can
Push the Pin Out and In with the Macro there I have config like betrue3D.dk.
If I want home Z after Homing XY the the Pin don’t push out.

Config.g

; Z-Probe
M307 H7 A-1 C-1 D-1 ; disable heater on PWM channel for BLTouch
M558 P5 H5 F120 T6000 Z2 ; set Z probe type to bltouch and the dive height + speeds
G31 P500 X60 Y60 Z2.5 ; set Z probe trigger value, offset and trigger height
M557 X15:380 Y15:350 S20 ; define mesh grid

Home.z

; Z-Probe
M307 H7 A-1 C-1 D-1 ; disable heater on PWM channel for BLTouch
M558 P5 H5 F120 T6000 Z2 ; set Z probe type to bltouch and the dive height + speeds
G31 P500 X60 Y60 Z2.5 ; set Z probe trigger value, offset and trigger height
M557 X15:380 Y15:350 S20 ; define mesh grid

If it’s possible to help me

In have try the M558 command with P5 and with P9

I use the Firmware 2.05

Phaedrux

Please post your homing files and the deployprobe retractprobe files.

Veti

@CupaCabra said in BLTouch Problem with Home Z:

P5

P9 is for bltouch