is the duet 3 board able to kill an attached raspberry?

littlehobbyshop

It couldn't be something as simple as the Pi SD card dying could it? Done that before.

Danal

@littlehobbyshop said in is the duet 3 board able to kill an attached raspberry?:

It couldn't be something as simple as the Pi SD card dying could it? Done that before.

Would not affect power LEDs.

spllg

@Danal do you you mean: shorting heater -> termistor? going to check tonight.

spllg

@littlehobbyshop i do not think so, because mounting it from my laptop (after filesystem repair) does work fine.

Danal

@spllg said in is the duet 3 board able to kill an attached raspberry?:

@Danal do you you mean: shorting heater -> termistor? going to check tonight.

Yes, that is one possible scenario. That would put 12 or 24 on the 5.

dc42

All generation 2 Duets survive shorting thermistor inputs to Vin, except some Duet WiFi v1.0 boards and the white Duet WiFi prototypes. See https://www.youtube.com/watch?v=uyWolKFzb-A.

Duet 3 boards have these and additional protection measures, which I hope to demonstrate in another video soon.

spllg

@Danal visually checked and measured the resistance between 12v/24v heater cables and cables to all other components at the print head and could not find any shortage.

A Former User

@spllg said in is the duet 3 board able to kill an attached raspberry?:

visually checked and measured the resistance between

can be tricky to locate a fault in a system that moves and heats up though. the meter also use much lower voltage to test, so if you have a leakage and not a straight up short it won't find it.

I should get some new terminals and housings one of these days, so I could try adding an isolator to my setup, but admittedly for the Pi to risk any damage odds are you're also risking damaging the Duet3, so imho it makes more sense to focus on protecting the Duet3 in the first place.

edit: just finished planning out the txs0108e, if anyone decides to try DO NOT use 5v to power the isolator on either the SBC or Duet3 side, both sides need 3.3v and you'll need to find 3.3v somewhere else on the duet (IO port, temp daughter board, swd port etc)
edit2: brain failure. txs does not isolate properly. will try some adum-something-something anther day

spllg

just reconfigured (set jumpers 'internal 5v enable' and '5v->sbc') and powered the duet from my 12v psu.
the duet seems to be working - at least the 4 leds left of the reset button are all glowing and the red led right of the reset button is blinking. because the rpi appears to be dead i cannot proceed to do further tests.

jay_s_uk

@spllg why not try it in standalone mode to confirm its fully functional?

spllg

@jay_s_uk this would be for academic purpose only because i am already waiting for a duet 3 replacement (other issue).

spllg

nevertheless it would be nice to know the reason for rpi's death.

was it faulty before?
did it commit suicide?
was it killed by an external event?
was it killed by the duet?

spllg

@dc42 <All generation 2 Duets survive shorting thermistor inputs to Vin, except some Duet WiFi v1.0 boards and the white Duet WiFi prototypes. See https://www.youtube.com/watch?v=uyWolKFzb-A.

Duet 3 boards have these and additional protection measures, which I hope to demonstrate in another video soon.<

did you do the same tests using a duet 3 with an attached rpi? did the rpi survive?