New to Duet and Reprap with questions
-
Will do on M500, M501
-
Hmmm... that looks OK to me.
Is tool 0 showing up in the web interface? And if so, showing what value?
-
It says N/A
-
Ah... is there a sensor physically plugged in? The web interface will say N/A on values until it gets its first reading.
-
Yes both temp 0 and temp 1, two 3950 thermistors connected, I just now went out to the garage and swapped temp 0 and temp1 thermistors with no change.
-
-
Interesting. I don't see anything wrong in the config. I'd expect to see -273.1 if nothing was connected.
N/A implies the Web stuff running in the browser (javascript) is not seeing a "key" in the json that is periodically returned. The object model. Again, though, I don't see anything that would prevent that.
Perhaps someone with sharper eyes will catch it when they look at that config.g.
If it helps in any way, here is a working config for a mult-tool printer. You can look at the sensor and heater and tool definitions and see if you see anything that helps.
-
Hey thanks for that, getting late here. I'll pick up on it tomorrow.
-
This post is deleted! -
Was able to get the temperature to display by editing the config.g file directly and rebooting.
