Duet WiFi scan for network keeps scrolling

cdalyai

The WiFi: scan for networks finishes it's scan and reports "scandone" and show's available networks and then continues to scan again and again in a constant cycle, and never stops.

Any Ideas?

A Former User

is it configured to connect to a network?

cdalyai

No, it is not connected to the internet it is scanning for a network. It locates my network and list it and then the scan reports the following…

WiFi reported error: no known networks found
WiFi module is idle
ESP reported status change
And after the reported status change it starts the scan all over again and stays in a loop.

Phaedrux

https://duet3d.dozuki.com/Guide/1.)+Getting+Connected+to+your+Duet/7

cdalyai

@Phaedrux

Thanks for the link, I've been their several times. But tonight I decided to start at step one and follow each step.
And by doing so was able to reconnect.

THANKS, THANKS & THANKS AGAIN..... You are now my BEST BUDDY

Phaedrux

I'm honoured.

JRDM

How are you scanning for WiFi networks on Duet? I can't find a g code command that does it and I only found a forum post from 2018 that says "it's on the list"

Phaedrux

@JRDM There is no scanning. You must provide the SSID and password of a 2.4ghz network within range for the Duet to connect to.

A Former User

@Phaedrux said in Duet WiFi scan for network keeps scrolling:

There is no scanning.

(it'll show the scan if you enable wifi debugging m111 p14 iirc)