Well I did the inevitable tried a voltage check on a fan terminal on my Duet WiFi, as you know the pins are quite close and I let the tester leads touch. Does this mean a new board or is there a work around?

Thanks Much for the link...

I’m just a beginner trying to modify and update my Delta printer. I’m installing a Duet Wi-Fi board and know this is a very elementary question for most hobbyists.
In wiring the Duet board I would like to know what is normally a Fan 0, Fan1, Fan2 and what fans are normally always on?
Thanks….

@Phaedrux

Thanks for the link, I've been their several times. But tonight I decided to start at step one and follow each step.
And by doing so was able to reconnect.

THANKS, THANKS & THANKS AGAIN..... You are now my BEST BUDDY

No, it is not connected to the internet it is scanning for a network. It locates my network and list it and then the scan reports the following…

WiFi reported error: no known networks found
WiFi module is idle
ESP reported status change
And after the reported status change it starts the scan all over again and stays in a loop.

The WiFi: scan for networks finishes it's scan and reports "scandone" and show's available networks and then continues to scan again and again in a constant cycle, and never stops.

Any Ideas?

@Phaedrux
Read your response and took a brake went and got sum Pizza and the solution was their. I resolved the problem, Heater 1 wiring was the red and Heater 2 was the black and they connect to the PWM FANS on the duet. Same for the Cooling Fan 1 and Cooling Fan2. You know how the solution is right in your face but you can't see it.
Thanks....

I brought a duet because of all the trouble I had with the original MKS subbase and need some help with a few connections.
I have a label that reads “Heater 1” and another label that reads “Heater 2” on my TLM, can you or someone else explain where these connect on a Duet3D Wi-Fi Board. Also I have a label “Cooling Fan 1” and a label “Cooling Fan 2” that I need help with also.
Thanks in advance, Chris

@bearer
Ok, Thanks again for your help.
consider this case closed...

@Danal
To make sure I’m on the same rabbit trail as you, would the following be correct.
If I exchange the current Duet2 Wi-Fi board for a Duet2 Ethernet board and connect it to my computer I could print directly from the computer via Duet Web Control?
Or would I be printing from my computer via printer firmware (Repetier-Host/Simpilify3D etc.) ?

And by the way thanks for your help and being there for hobbyist like me.