G code

[minsk]

hey guys getting closer and closer to getting my large format printer pooping…have the x-axis all set up...question...i wanna run the x 100mm is there a way to do that...or is there away to do more than 10mm of motion at a time...am i missing something...

[DjDemonD]

Not sure what you mean if you want x to move 100mm send
G1 X100 F1000 to move to the 100mm position on the x axis (after homing). Change the 1000 to a higher or lower number to change speed.
Or do you mean something else?

[minsk]

nope.
thats it .
thank you .

i just didn't know the correct g code.

minskmade