ahhh…got it...thank you sir
wiring up my end stops now

mmmk..
so i have a diff kinda build.
im using 4 motors
18x18 square.

i have is kinda set up as an xy i guess..but not really
i have one motor on x…one motor on y.... 2 motors on zed
2 motors on z because it will be lifting an 18 inch bed
my question is how do i hook the two z motors up to the duet wifi

i did a new config file on reprap and did the cartisean.
now the axis are working properly on ax and y
moving individually
on to drilling holes in my 20x20 bed...this should be fun

oh snap…i think you are right

So upgraded firmware for panel Due and all works now…not a bad cable

so have x and y wired up on my large format printer im building.
when i click to move x 100 mm y moves also…
hmmm

when i click y to move 100 mm x moves also

they are of course wired seperately..all go in to there respective ports on the wifi board etc.

EDIT: ok weird…z is not hooked up and if i click z on the screen x and y move also

any ideas would be a appreciated

my panel Due has a red bar and just says connecting.
cant control motor movement thru lcd

any help is appreciated

thank you

daniel

nope.
thats it .
thank you .

i just didn't know the correct g code.

minskmade

Capt Awesome….the controller for Duet is browser based so you can us i on any device..it works great.

hey guys getting closer and closer to getting my large format printer pooping…have the x-axis all set up...question...i wanna run the x 100mm is there a way to do that...or is there away to do more than 10mm of motion at a time...am i missing something...

is this the one indiana?