Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Inductive sensor as endstop

Duet Hardware and wiring

3

3

140

Log in to reply

undefined

Headhunter
last edited by

Hello,
i want to connect a LJ8A3-2-Z/AX (10-30VDC / 200mA) as Endstop for Extruder. How can i wire it, so it will work? Endstop gives out only 3.3v
? undefined 2 Replies Last reply
Reply Quote 0
?

A Former User @Headhunter
last edited by

@Headhunter said in Inductive sensor as endstop:

LJ8A3-2-Z/AX

the *AX sensors are NPN type, meaning its output is essentially 0v. Wire the sensor supply to Vin (10-30v), Gnd to Gnd and output to endstop signal.
1 Reply Last reply
Reply Quote 0
undefined

gtj0 @Headhunter
last edited by

@Headhunter said in Inductive sensor as endstop:

LJ8A3-2-Z/AX

This should help you out...
https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe
1 Reply Last reply
Reply Quote 0

1 / 1