Thermistors not detected
-
My Duet 2 Wifi displays temperatures of 2000c for all thermistors, consistent with an open circuit.
I have tried several thermistors in case the one I was using was bad.
My Config.g includes the following:
"M308 S1 P"e0temp" Y"thermistor" T100000 B4138 ; configure sensor 1 as thermistor on pin e0temp"
When I connect a 220k resistor instead of a thermistor, the temperature reading does not change.
Any idea what could be causing this? -
Solved, my firmware needed an update
-
Were you perhaps using RRF3 config on a RRF2 board?
-
@Phaedrux Yes, that was exactly what was happening
