printing time and data.
-
Recently I start a print and my slicer told me arround 21Hrs, I know that is not the right time, it took less then 21Hrs. Is there a way to see the printing time after the is done?
-
you can run a simulation on the same file to get an accurate number (would also work before printing). Might take a few minutes on a large print though.
-
@bearer great thanks I will try.
-
The printing time appears in “enventlog.txt” if you have it activated whit M929 P"eventlog.txt" S1
-
@1ri I put this M code in the config or in each gcode?
-
@Ladusse
Put it in the config.g
