Duet 3 Tool Board motor driver issue
-
Hi,
Do you have a tool defined?
Frederick
-
@fcwilt said in Duet 3 Tool Board motor driver issue:
Hi,
Do you have a tool defined?
Frederick
This what I have
; Tools
M563 P0 S"Frankenstein" D0 H1 F0 ; define tool 0
G10 P0 X0 Y0 Z0 ; set tool 0 axis offsets
G10 P0 R0 S0 ; set initial tool 0 active and standby temperatures to 0C -
Hi,
Did you try this from the docs:
Check that you can communicate with the Tool Board, by sending M115 B121 (if that fails, try M115 B10).
Frederick
-
@fcwilt said in Duet 3 Tool Board motor driver issue:
Hi,
Did you try this from the docs:
Check that you can communicate with the Tool Board, by sending M115 B121 (if that fails, try M115 B10).
Frederick
Communication with board is fine:
M115 B121
Board TOOL1LC firmware 3.1.0 (2020-05-15b1)Heater and temperature reading also work
-
Hi,
I notice that in the docs for the tool board they suggest using 20 for the first tool board address.
Perhaps the current firmware has a problem with numbers like 121 for E?
That, however, seems like grasping at straws.
How about as a test change Z to just Z0.2 and see what happens?
Frederick
-
Sorry guys, my fault. It's my change filament macro.
-
This is my first Duet board.
-
@evomotors said in Duet 3 Tool Board motor driver issue:
Sorry guys, my fault. It's my change filament macro.
No problem
But could you explain what the macro did that caused the issue?
Thanks.
Frederick
-
@fcwilt said in Duet 3 Tool Board motor driver issue:
@evomotors said in Duet 3 Tool Board motor driver issue:
Sorry guys, my fault. It's my change filament macro.
No problem
But could you explain what the macro did that caused the issue?
Thanks.
Frederick
I had it
G28 ; homein the filament config.g file
-
Thanks for the reply.
As you found out you don't want to do that.
Just FYI, the things I set in my filament config files are the hotend temp, bed temp and extrusion multiplier.
Frederick
