Duet 3 Tool Board motor driver issue

evomotors

I'm commissioning new 3d printer with 3 independents Z motors. Duet 3 with tool distribution board, Tool Board and SBC.

This is what in my config
M584 X0.0 Y0.1 Z0.2:0.3:0.4 E121.0 ; set drive mapping

When I press load filament the middle Z motor getting triggered instead of E0

Am I doing something wrong?

Scachi

@evomotors said in Duet 3 Tool Board motor driver issue:

E121.0

looks like the steps and not like a drive ID

evomotors

@Scachi said in Duet 3 Tool Board motor driver issue:

@evomotors said in Duet 3 Tool Board motor driver issue:

E121.0

looks like the steps and not like a drive ID

121 is Tool board address and 0 is driver address

fcwilt

Hi,

Do you have a tool defined?

Frederick

evomotors

@fcwilt said in Duet 3 Tool Board motor driver issue:

Hi,

Do you have a tool defined?

Frederick

This what I have
; Tools
M563 P0 S"Frankenstein" D0 H1 F0 ; define tool 0
G10 P0 X0 Y0 Z0 ; set tool 0 axis offsets
G10 P0 R0 S0 ; set initial tool 0 active and standby temperatures to 0C

fcwilt

Hi,

Did you try this from the docs:

Check that you can communicate with the Tool Board, by sending M115 B121 (if that fails, try M115 B10).

Frederick

evomotors

@fcwilt said in Duet 3 Tool Board motor driver issue:

Hi,

Did you try this from the docs:

Check that you can communicate with the Tool Board, by sending M115 B121 (if that fails, try M115 B10).

Frederick

Communication with board is fine:
M115 B121
Board TOOL1LC firmware 3.1.0 (2020-05-15b1)

Heater and temperature reading also work

fcwilt

Hi,

I notice that in the docs for the tool board they suggest using 20 for the first tool board address.

Perhaps the current firmware has a problem with numbers like 121 for E?

That, however, seems like grasping at straws.

How about as a test change Z to just Z0.2 and see what happens?

Frederick

evomotors

Sorry guys, my fault. It's my change filament macro.

evomotors

This is my first Duet board.

fcwilt

@evomotors said in Duet 3 Tool Board motor driver issue:

Sorry guys, my fault. It's my change filament macro.

No problem

But could you explain what the macro did that caused the issue?

Thanks.

Frederick

evomotors

@fcwilt said in Duet 3 Tool Board motor driver issue:

@evomotors said in Duet 3 Tool Board motor driver issue:

Sorry guys, my fault. It's my change filament macro.

No problem

But could you explain what the macro did that caused the issue?

Thanks.

Frederick

I had it

G28				; home

in the filament config.g file

fcwilt

@evomotors

Thanks for the reply.

As you found out you don't want to do that.

Just FYI, the things I set in my filament config files are the hotend temp, bed temp and extrusion multiplier.

Frederick