Duet 3 and Creality CR 10 MAX
-
Apologies, I have another question.
Would a Duet 3 Toolboard 1LC be useful for a DirectDrive setup? I am not sure how much weight it would add to the whole setup, but I imagine it wouldn't be much.
Must admit I enjoy the idea of having just two wires running to the DirectDrive. -
@war4peace said in Duet 3 and Creality CR 10 MAX:
Must admit I enjoy the idea of having just two wires running to the DirectDrive.
4 wires. 2 data and 2 power wires
-
Yes, I meant two pairs, sorry.
Certainly better than the bundle I have right now
-
Update: after leaving the printer off and unplugged from power for almost 48 hours, I turned it back on and the extruder motor is working again. This reinforces my suspicion, it's the motherboard or breakout board acting up.
So yeah, I will go ahead and order the Duet 3.
-
@war4peace said in Duet 3 and Creality CR 10 MAX:
his reinforces my suspicion, it's the motherboard or breakout board acting up.
it could also be a bad crimp on the cable.
-
@Veti said in Duet 3 and Creality CR 10 MAX:
@war4peace said in Duet 3 and Creality CR 10 MAX:
his reinforces my suspicion, it's the motherboard or breakout board acting up.
it could also be a bad crimp on the cable.
The cable is the default one which comes with the motor. I have taken precautions so that the wires won't move in relation to the places they're connected to while the printer is doing its job. Previously I had a different cable, and same issue occurred.
While I can't fully rule out this possibility, it's highly unlikely. -
are you on firmware 3.1.1?
-
I'm not sure what you mean, the stock motherboard uses Marlin firmware and I have upgraded it from 1.7.0 (Creality made) to 2.0.5 (TinyMachines 3D).
-
@war4peace
forget it. there was a bug an early firmware version of duet. but this does not apply here. -
I getting a CR10 max delivered here tomorrow. I'm also planning on a Duet 3 and Tool boards, already received. Yes, overkill but I like the quality of the hardware. Throwing out the control it comes with. I'll let you know how it goes.
