Unsolved Motor issue, step forward and backward when change direction.
-
Today I've made a visual control printing test without filament and still produce the same hitch in the motor of Y axis.
-
to sum up.
you changed to driver on the duet to a different port -> no change
you changed the motor and its wiring -> no changedo you have pressure advance active?
did you try a differnet slicer?
-
@Veti said in Motor issue, step forward and backward when change direction.:
pressure advance active
Sorry, but, dont know what "pressure advance active" is. Where can I find it?
I've tried, simplify3d, repetier, prusaslicer and cura, and all get the same results.
-
@Pasquk2 said in Motor issue, step forward and backward when change direction.:
Sorry, but, dont know what "pressure advance active" is. Where can I find it?
https://duet3d.dozuki.com/Wiki/Pressure_advance
M572
-
If this must be in config.g file, I don't find it.
-
most of the time you put it the in the start g code of a file.
you can also just send M572 D0 in the console to query the current value
-
This is the result of m572 D0:
-
I'm going to erase all and reload the firmware again, begining from 0.
-
That means pressure advance is disabled. So that's fine.
-
Hi all again.
This weekend I've been so busy with my printer and tried many things. I have reset the board, erase sd card, reloaded all files, all firmware, and saddly all runs the same way. Still this bullshit movement in the motor.
I think there is some problem with the duet. Maybe some component broke.
I'll try more.Thanks all.