external stepper motor drive usinh MH6Hc main board
-
hii. We have DUET 3 motherboard MB6HC, we need to connect four external stepper motors and deiver. "NEMA34 12Nm motor 86EBP181ALC and driver ZDM-2HA865 closed loop stepper motor driver. so how we can connect External motor and which board we required to setup.
-
you'll need some of these https://www.duet3d.com/Duet3Expansion1XD
contact duet3d directly to see if they have any for sale (I believe they have stock).
You can't connect external drivers directly to a 6HC board -
in this board where is the stepper motor expansion pin showing like, pulse, direction, enable. and how many motors we can connect.. We required 4 external stepper motor port
-
heres the documentation link https://duet3d.dozuki.com/Wiki/Duet_3_Expansion_1XD
you will need to purchase 4, 1 for each driver.@T3P3Tony the documentation link on the duet website is pointing to the toolboard rather than the expansion board
-
@jay_s_uk any other expansion board can be use , because this item out of stock.
-
@dkraja42 they have stock, you just need to email them.
sales@duet3d.com I think