Small chip burned out.
-
Hello.
My printer had a bad connection of temp sensor and I was leaving it for a few minutes.
Then small chip near by CPU made smoke and burned out.
Maybe the connection to the sensor was short circuit.After it was burned out, I turned the switch on.
But found there was no problem.
Even the temperature was shown at the right temperature.
So my question is
What was burned out ?
What was this chip for ?
Do somebody know the part number of this ?
-
looks like the VSSA fuse, which suggest a short in thermistor for bed/hotend to a heater.
https://duet3d.dozuki.com/Wiki/Connector_and_spare_part_numbers#Section_VSSA_fuse
think there may different sizes for different revisions of the board however
