@fcwilt Hello.
Oh, I got it.
Yes, Deployprobe.g is
M280 P7 S90
and retractprobe.g is
M280 P7 S10

@hiroaki said in CoreXY or Cartesian which is better ?:

Hello there.
I have made some CoreXY printers and one Cartesian (which moves heating bed for X axis) but I am wondering if Cartesian which moves the nozzle X and Y axis is better than CoreXY to make the machine more accurate.
If there is anyone who has made both CoreXY and Cartesian which moves the Nozzle for both axis, please give me your idea.
Regards

Everybody Thank you.
Please take a look at the photo.
My question is whether COREXY or cartesian has better position accuracy, assuming a printer like this one. 　Sorry for confusing...

@o_lampe I think you can egt better result if you increase the retruction ammount. Mine is at this moment 5mm.
Or If your printer is borden, the teflon tube between extruder and nozzul has too much friction or too long.
So when extruder motor stops to stop extruding, it contines extruding.
The following guys had a video how to tune your printer I think.
https://www.youtube.com/watch?v=TDxpVSXmKiE

https://www.youtube.com/watch?v=3yIebnVjADM&t=485s

@weed2all Thank you so much!

Hello there.
Please take a look at the photo, This is a photo I printed with my printer, this is aprox 400 mm from the bed.
My printer has two 12mm diameter rods to keep the bed right position up and down.
I guess, this unevenness is caused by the displacement of the bed.
Are there any bod who tried rods, linear guide etc for Z axis and which one is the best ?

Re: Wifi get disconnected when trying to connect by DWC
Long time ago I made a little problem with the wifi module on my Duet2wifi.
(I did something like short circuit)
At that time I did following according somebody's advise.

You can reflash the wifi server firmware with M997 S1
You can clear all saved wireless networks with M588 S"*"
And readd your network with M587

It got back to OK, at that moment, for a while I didn't use the printer and now turned the switch on and found that the wifi module is BAD again.
Again I tried the same way but this time when I did M588 S"*", the error
"Failed to reset the WiFy module to factory setting.
Does this mean, the wifi module is really broken ?
Please help.

Hello.
Please help.
I am just now trying to change my 3D printer from Duet2wifi to Duet3.
And having a question to set BL touch on the board 121 in Reprap configurator.
Could someone tell me the setting for these three vales?
Thank you.

@t3p3tony Hello. I appriciate it.

Sorry I would have put, the connection is reversed.

Hello
I have just found that the CAN connection (RED and Black) in this picture is reversed...!

@weed2all Thank you so much!

@oliof Thank you so much!

Hello There.
Now I am changing the board from Duet2wifi to Duet3, I am just wondering what is the advantage of using a SBC with it .
Can somebody list the good points and maybe bad points ?

@phaedrux Hello Thank you so much ! I will do it.