-
@Phaedrux said in ERROR: 409 / BAD COMMAND / WARNINGS:
versions are you running on the Duet and the PanelDue?
Sorry.. PanelDue 5'' v2
PanelDue firmare reupdate and connection checked, but the problem still exist.
-
@maicolspazzini which processor is on the panel due I believe that not all V2's can run 3.2.6 FW.
-
@Dougal1957 How can I check the processor?
If the problem is the 3.2.6, i'll install an other one older.
But the older, it's comparible
with Duet Firmware 3.2? -
@maicolspazzini I suspect you will have to separate the PanelDue from the display and read the name/part number on the MCU Chip.
Sorry can't help any more than that but I do know that the earlier V2's arnt supported will need Wilriker to confirm whether the FW will even load on that device mind.
-
You can try paneldue fw 1.24
-
@Phaedrux said in ERROR: 409 / BAD COMMAND / WARNINGS:
ou can try paneldue fw 1.24
I update to 1.24, but with 3.2rc2 the problem still persist.
Now i'll try to downgrade to 3.1.1, Do I have to follow a particular procedure to do that? -
When connected via USB and Bossa, you should be able to gather some information on what chip is in there.
But the fact the errors are persisting I would think it's more likely the wiring.
Does it run next to endstops or motors?
What baud rate do you have set?
You can improve the wiring with thicker wires and shielding and perhaps give them a twist or braid.
-
@Phaedrux said in ERROR: 409 / BAD COMMAND / WARNINGS:
When connected via USB and Bossa, you should be able to gather some information on what chip is in there.
But the fact the errors are persisting I would think it's more likely the wiring.
Does it run next to endstops or motors?
What baud rate do you have set?I install 3.1.1 Firmware, PanelDue 1.24, printer is working but error still exist..
-
how long is your cable?
you can try braiding the cable to reduce interference.
-
